Instructions for using ultrasonic flowmeter | Wilson WSF-100 ultrasonic flowmeter manual: [4]

『Instructions for using ultrasonic flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

How to use a flange pipeline ultrasonic flowmeter?

Using a flanged pipeline ultrasonic flowmeter for vertical flow measurement usually requires the following steps

1. Installing the flange: Install the flange on the pipeline to be measured, ensuring that the flange is tightly connected to the pipeline.

2. Installing the sensor: Install the ultrasonic sensor onto the flange, ensuring that the position and direction of the sensor meet the equipment requirements. In order to reduce data measurement errors, the position of the sensor should be as close as possible to the center of the pipeline. 3. Connect the power and signal lines: According to the equipment manual, connect the power and signal lines of the ultrasonic balance wave flowmeter. After confirming the correct connection, turn on the power and the device can start working

4. Testing and debugging: After the device is installed and starts running, it needs to be tested and debugged to ensure measurement accuracy. The parameters and detection methods of the flowmeter can be set according to the equipment manual. General operating procedure: - Set flow parameters: Input parameters such as pipeline diameter, flowing medium type, temperature, pressure, etc., for equipment positioning and accurate measurement of flow data. -Perform measurement: Follow the instructions in the equipment manual and perform flow measurement. Measure many times, record each data, and finally perform residual analysis and processing on the data to obtain the results. -Adjustment and calibration: By comparing the measurement results with the actual values, co

2. Wilson WSF-100 Ultrasonic Flow Meter Instruction Manual: [2]

The Wilson WSF-100 Ultrasonic Flow Meter Instruction Manual mainly covers product usage methods and common troubleshooting solutions. Product usage method: Installation requirements: The flowmeter should be installed on the straight pipe section to ensure stable fluid flow. The length of the upstream straight pipe section is recommended to be more than 10 times the diameter of the pipeline, and the downstream should be more than 5 times, avoiding installation near interference components such as elbows and valves. Sensor installation: The sensor needs to be in close contact with the outer wall of the pipeline. Before installation, the surface of the pipeline should be cleaned to remove impurities such as rust and paint, and a special coupling agent should be used to ensure the quality of signal transmission. Parameter setting: Set parameters such as pipeline diameter, fluid type, and range through the flowmeter panel or supporting software to ensure measurement accuracy. Operation process: After turning on the device, a self check is required to confirm that the sensor signal is normal before starting the measurement and guessing process. Real time data such as flow rate and velocity are displayed, and the state difference supports data storage and export functions. Common troubleshooting

『SILVER Official Website SERVICE』