Flow meter direction | Installation direction of mass flow meter

『Flow meter direction』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

1. Is the flow meter in front of the five finger arrow or behind the arrow?

The first five and the last three refer to the straight pipe section distance of 3 or 5 times the diameter (unit) in front or behind the rock search surface where the pipeline is opened. For example, if the flow meter is DN100, there should be a 5 * 100mm straight pipe section at the front and a 3 * 100mm straight pipe section at the back to ensure proper distance. The calculation method refers to Wang Shens figure below:

2. How to view the direction of the flowmeter

The direction of the flowmeter needs to be determined based on the type through identification arrows, internal structure, or instructions. The core method is as follows:

1. The determination of the fluid direction of the sail, equipment, water meter mainly relies on two points: 1 Dial Arrow: The dial is cast with arrow markings, and the direction of the arrow indicates the direction of water flow. two Import and export labeling: The table body is usually labeled with "inlet" and "outlet", with water flowing from the inlet to the outlet. The direction of water flow impact on the internal impeller is consistent with the arrow.

Secondly, the flow arrow stopper on the electromagnetic flowmeter housing or sticker is the core judgment basis.

III. The smoothness of turbine rotation in a turbine flowmeter depends on the flow direction: 1 Shell arrow: The flow arrow marked

4. The installation direction of the ultrasonic flowmeter sensor determines fluid recognition: 1 Instructions: The upstream sensor (transmitter) and downstream sensor (receiver) need to be fixed at the specified distance and direction. two Sensor identification: Some sensors are marked with the symbol "Fluid →" on their surface, and should be aligned with the flow direction inside the pipeline during installation. In practical operation, if the identification is missing, the operating status of the equipment can be observed: for example, when a mechanical water meter is installed in reverse, the impeller does not rotate or reverses, and when a turbine flow meter is installed in reverse, the counter may reverse or stall. Can turbine flow meters be installed at 90 degrees? The installation direction of the turbine flowmeter directly affects its measurement accuracy and stability. According to industry standards and technical specifications, turbine flow meters are usually recommended to be installed horizontally, but vertical or inclined installation is allowed under specific conditions. The feasibility of 90 degree installation (i.e. vertical installation) needs to be comprehensively analyzed from the following aspects:

Firstly, the technical requirements for vertical installation are to limit the fluid direction. When installing vertically, the fluid must flow from bottom to top (webpage

1, webpage 2) to ensure that the

『SILVER Official Website SERVICE』