What does "flow meter" mean in English | 5 days before and 3 days after the flow meter

『Flow meter in English』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

1. Flow meter English

The English for flow meter is flowmeter.

1. Synonyms

1. Fluid meter.

2. Flow counter flowmeter.

3. Effort meter flowmeter.

4. Bulk flowmeter.

5. Flow instrument flowmeter.

6. Flow gauge (FG) flowmeter.

7. Under meter flowmeter.

8. Totameter flowmeter.

9. Weir gauge flowmeter.

2. Similar words

1. Flow traffic.

2. Specific traffic ratio.

3. Specific traffic ratio.

4. Omnidirect omnidirectional traffic.

5. Full traffic.

6. stall stall flow rate.

7. Dominant dominates traffic.

8. Pumping pump flow rate.

9. Flow flow switch.

10. Rate traffic rate.

1. The influence of CO2 concentration on the accuracy of ultrasonic gas flow meters.

2、V Numerical simulation study on surface pressure distribution of cone flowmeter. Numerical Simulation of Surface Pressure Distribution of Cone Flowmeter Based on Fluent Code.

3、 This flowmeter can handle gas, liquid, foam and slurry. The meter handles gases, liquids, foams, and slurries.

2. Relevant information on flow meters? The advantages of electromagnetic flowmeter are minimal pressure loss and a wide range of measurable flow rates. The ratio of maximum flow rate to minimum flow rate is generally above 20:1, suitable for a wide range of industrial pipe diameters, up to 3m. The output signal is linear with the measured flow rate, with high accuracy. It can measure the fluid flow rate of acid, alkali, salt solutions, water, sewage, corrosive liquids, as well as mud, slurry, pulp, etc. with conductivity ≥ 5 μ s/cm. But it cannot measure the flow of gas, steam, and purified water. When a conductor cuts magnetic field lines in a magnetic field, an induced electric potential is generated in the conductor, and the magnitude of the induced electric potential is proportional to the effective length of the conductor in the magnetic field and the speed at which the conductor moves perpendicular to the direction of the magnetic field. Similarly, when a conductive fluid flows vertically in a magnetic field and cuts magnetic induction lines, it will also generate induced potentials on the electrodes on both sides of the pipeline. The direction of induced potential is determined by the right-hand rule, and the magnitude of induced potential is determined by the following equation: Ex=BDv -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- It can be seen that when the diameter D of the pipeline is fixed and the magnetic induction intensity B remains constant, the measured volume flow rate is linearly related to the induced potential. If an electrode is inserted on each side of the pipeline, an induced potential Ex can be introduced, and the magnitude of this potential can be measured to obtain the volumetric flow rate. According to Faradays principle of electromagnetic

『SILVER Official Website SERVICE』