Current position > Product detail
『Clamp on vortex flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Flange type vortex flowmeter?
The sensor output frequency signal of a flange type vortex flowmeter or flow meter is usually combined with a computer or flow integrator to form a flow measurement system. The transmitter outputs a 4-20mA standard signal proportional to the volumetric flow rate, which is usually combined with a computer to form a flow measurement system or other flow integrator to form a flange type vortex flowmeter. The sensor/transmitter of the flange type vortex flowmeter is installed on the pipeline, and the flow integrator or computer is installed in the control room and provides power to the vortex flow sensor/transmitter. The two are connected by shielded cables.
2、 The sensor structure is simple: there are no movable parts inside the measuring tube, nor are there any throttling components that hinder fluid flow. Therefore, when the fluid passes through the flowmeter, it will not experience any additional form of pressure loss, making it one of the flow meters with lower energy consumption for heavy operation.
3、 A volumetric flow measurement instrument: During the measurement process, it is not affected by the viscosity, temperature, density, or conductivity of the measured medium. So the vortex flowmeter can be used to measure the flow rate of other conductive liquids after being calibrated with water. Tuanshi
4. The flowmeter has no mechanical inertia: it reflects sensitively and can measure instantaneous pulsating flow, as well as both forward and reverse flow.
5、 The output is only proportional to the average flow velocity of the measured medium, and is independent of the flow state under symmetric distribution. Therefore, the range of the vortex flowmet
1, and even up to an operational flow range of 1000:1.
2. I would like to know what the YDFC-HDHD model of the Velbar flowmeter means, as well as its compatibility with the Android system ..
Cant this model be easily found on Douniang? The model YDFC-HDHD of the Weiliba flowmeter, produced by Sichuan Fenci Automation Instrument Co., Ltd., is used to measure the flow rate of fluids in order to better monitor and control the industrial process. HDHD means caliber H is 150 degrees D, stainless steel H is 120 degrees D, and nanofront pressure is 1.6 Mpa. This is the model they selected for high scores.
3. Common connection methods for flow meters
In contemporary industry, it is often necessary to measure the flow rate of fluids in order to have better monitoring and control of the industrial process. Therefore, flow meters have emerged. Different industrial development directions have led to various flow meters, such as rotor flow meters, turbine flow meters, electromagnetic flow meters, vortex flow meters, etc. The connection method of each flowmeter is different. According to the customers requirements for slag handling, even for the same type of flowmeter, the connection method may not be the same. The design, selection, purchase, and maintenance costs of the flowmeter connection method are important factors in the use of the flowmeter. Next, Qin Wei Instrument will introduce the four commonly used connection methods for flow meters.
1. Flange connection: This connection method is the most commonly used. Electromagnetic flow meters, turbine flow meters, Roots flow meters, and so on all have this connection method. Just