Current position > News detail
『Calculation of underfloor heating flow rate』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
What is the normal flow rate for household underfloor heating?
1. Calculation of minimum water flow rate for underfloor heating: For a 100 square meter residential building, according to the formula, the hourly water flow rate should be at least 0.19 cubic meters
2. Impact of heating branches: If four heating branches are installed late in a home, the total underfloor heating flow rate should be 0.76 cubic meters per hour, which is considered normal.
. 3. Building area and heating index: Taking a 100 square meter residential building as an example, assuming a heating index of 60 watts per square meter, the total heating load will be 6000 watts, or 6 kilowatts. 4. Water flow calculation: According to the water flow formula (heating power x thermal efficiency coefficient)/temperature difference, the result is 0.516 cubic meters per hour. 4, which is 0.76 cubic meters per hour.2. What is the normal flow rate of underfloor heating
1. There are two calculation methods for the design of underfloor heating main pipeline flow rate: one is determined by heating load and supply and return water temperature difference; The other type should meet the minimum water flow rate requirement for underfloor heating coils, and the larger of the two should be taken.
2. Taking a residential building with a building area of 100 square meters as an example: heating heat index: 60W/square meter; Heating load: 100 × 60=6000W=6kW; Water flow rate: (6 × 0.86)/10=0.516m3/h. The result of calculating the above technical parameters is: G minimum=3.14 × [(0.02-0.004)/2] 2 × 0.26 × 3600=0.19m3/h, which means that the minimum water flow required for a single underfloor heating coil is 0.19m3/h. If the re
_600x400.jpg)
3. If the water flow rate is determined based on the warm load of the harvesting area and the temperature difference between the supply and return water, it will cause frequent gas accumulation in the engineering system, resulting in overheating. The reason behind this is that insufficient flow caused air blockage, which disrupted the system circulation. Therefore, the design flow rate must meet the minimum water flow rate requirement of the underfloor heating coil to avoid the accumulation of air in the system affecting the heating effect. When the design flow is limited, the indoor branch number should be adjusted accordingly.
3. What is the normal flow rate of underfloor heating?
The normal range of underfloor heating flow rate is 0.15 to 0.25 cubic meters per hour.
. Taking a 100 square meter residential building as an example, the heating load can be calculated based on 60 watts of dry rubber per square meter, totaling 6000 watts or 6 kilowatts. The water flow in the underfloor heating system needs to be able to transfer sufficient energy to meet the heating needs of the room. Based on this calculation, the water flow rate is approximately (6 kW multiplied by 0.86) divided by 10, resulting in approximately 0.516 cubic meters per hour.4. Calculation and selection method for underfloor heating circulating water pumps
The selection of underfloor heating circulating water pumps should be based on hydraulic calculation results, combined with system flow, resistance, and pump efficiency curves, to select the model that meets the maximum flow and resistance requirements and o