Current position > News detail
『Flow meter parameter settings』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Parameter Setting of IFM Flow Meter SD6020
The parameter setting of IFM Flow Voltage Chamber Meter SD6020 mainly involves basic parameter configuration, output signal selection, and advanced function setting, which can be completed through device buttons or supporting software. 1. Basic parameter setting • Range setting: Set the flow measurement range (such as 0-XXX L/min, the threshold needs to be set according to the actual working conditions). Sensitivity adjustment: Match the signal output of physical quantities such as compressed air flow rate, consumption, or temperature. • Unit switching: Supports flow unit selection such as liters/minute, cubic meters/hour, etc.
2. Output signal configuration • Signal type: optional switch quantity (normally open/normally closed mode, window mode), analog quantity (4-20mA), pulse signal missing signal or IO Link communication. Analog output range: Customizable flow range corresponding to 4-20mA (such as 0-1000 L/min). • Switch threshold: Set the critical value for flow triggered switch action (such as over limit alarm or device start stop)
3. Advanced function settings • Filter adjustment: Set filtering parameters (such as time constant) through software to suppress flow fluctuation interference. Communication protocol: Supports RS485
5, MODBUS and other protocols, requiring configuration of address, baud rate and other parameters. • Calibration function: Standard calibration equipment needs to be used for calibration, or calibration coefficients need to be entered into the system to correct errors.
4. Installation and electrical connection - During installation, ensure that the sensor is parallel to the fluid flow direction and away from str
2. How to set the flow switch parameters for a flowmeter?
The setting of flow switches usually includes setting flow thresholds, alarm thresholds and points, as well as other related parameters. The specific steps may vary depending on the type of flow meter (such as electromagnetic flow meter, float flow meter, turbine flow meter, etc.) and brand.. The following is a general general process: 1. Determine the flow threshold: The function of the flow switch is to send a signal when the fluid flow exceeds or falls below a predetermined specific flow rate. Firstly, you need to determine the appropriate upper or lower limit of flow rate based on process requirements or safety regulations. For analog flow switches, it may be necessary to turn the knob to set the threshold scale. -For digital flow switches, usually navigate to the flow threshold setting interface through the menu, and then enter or adjust the value through buttons
4. * * Set alarm function * *: - It may be necessary to set the on/off alarm, delay time, output signal mode (such as relay contact action, analog signal output, etc.) and high/low flow alarm points
Accurately trigger corresponding actions under traffic conditions. For specific models of flow switches, it is necessary to refer to their product manual or contact the manufacturers technical support for detailed ope